Miscellaneous mic shockmount

Published on February 28th, 2014 | by Ola Johansson, Sweden

4

Simple Microphone shock mount





20140121_2150461_c

Materials: ORDNING Cutlery stand and about 1 meter of shockcord (6mm)

I was able to build a cheap shock mount to reduce noise (cause by vibrations) from the desk and keyboard to the microphone.

mic shockmount
20140126_205127c fvtdc

See more of the custom shock mount.

Buy shock mounts.

Greek Key Golden Vittsjo
SkateBoard Deck Display-Hack

4 Responses to Simple Microphone shock mount

  1. Colin says:

    Be careful of the capsule getting too low into that cup, you could get some gnarly comb filtering. A cool trick would be to put some acoustical absorption foam inside the can to isolate the cap (if theres even enough room to do that).

  2. brin says:

    a REAL useful hack, and still looking good -

    congretulation and thankyou!

    brin

  3. Paul says:

    Just wondering, how tight is the shock cord? As in is 1 meter about fine or do you stretch it out a bit?

  4. Ola Johansson says:

    About 1m. Use a clamp to hold it while you install the cord between the holes, not mutch stretch is required.

Leave a Reply

Your email address will not be published. Required fields are marked *

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <strike> <strong>

Back to Top ↑

  • Null
    CoverCouch
    Null
    Overlays
    Null

  • Knesting

    Covercouch


  • See the Best of the Best

    See the Best of the Best

Twitter Auto Publish Powered By : XYZScripts.com