IKEA LAGAN Turntable Plinth

IKEA sells a range of hardwood counter top available in a variety of materials. I managed to get the beech wood LAGAN series (at least in my country – Singapore) and had it cut up for making of a turntable plinth.

Vintage turntables were sold with flimsy plinths and some even encouraged buyers to build their own. The Lenco is a well designed Swiss made turntable that suffered from one such flimsy plinth. There’s a lot written out there about Lencos and how the sound can be improved with a heftier plinth. This project is details construction of a plinth using the IKEA LAGAN. The end result is shown below.

IMG_5941

Life starts as Lagan hardwood counter top from IKEA.

IKEA Lagan counter top

It’s then loving cut up. 😉

measure twice, cut once

cutting up the Lagan

IMG_4859

The best cuts are chosen for making the plinth.

the best cut

The cut out is then traced using carbon paper onto the top layer. This cut out would be different for different models of turntable. The below cut out is specific for the Lenco PTP project. More information on the PTP project can be found here.

IMG_5115

IMG_5116

Next comes cutting up the required parts.

IMG_5164

And continue with layers 2 and 3.

IMG_5166

Overlay the actual metal pieces as guides for drilling holes. These holes are meant for attaching e-nuts that can be screwed down.

IMG_5167

IMG_5168

Screwing in the e-nuts. The metal e-nuts are screwed into the drilled holes.

IMG_5179

Next, mark out the tone arm mount point. This depends on your tone arm details and can be found as the pivot to spindle distance. It varies depending on the arm length. So, if you are using a 12″ arm, make sure your plinth dimensions can cater for this.

IMG_5374

IMG_5375

IMG_5376

Then comes cutting the hole for layers 2 and 3. Mark out with the first layer on top, and use a pencil to outline. I used a larger hole for these layers as i need to be able to screw down the nut that holds the arm.

IMG_5377

IMG_5380

Then glue down all layers, using clamps to hold the work piece overnight.

IMG_5431

Sand down the edges to get it as even as you can. It’s tough work here…

IMG_5430

IMG_5572

Apply a finishing layer. In my case, i chose to use an epoxy resin called Crystal Sheen. Depending on what’s available in your locale, you may have something different. But an epoxy resin can give you very nice results and one coat is as good as 50 coats of varnish.

IMG_5919

IMG_5917

Mounting the parts onto the plinth.

IMG_5931

Playing music in the rig!

IMG_5939