A password will be e-mailed to you.


Materials: Expedit, Linnmon

Description: I live in a duplex in which the upper floor has an inclined ceiling. In a corner I have my computer desk, and behind my back the ceiling is pretty low, and I need to make the most of it. So I thought of something like this, using three 2×2 EXPEDIT modules on wheels with a LINNMON table top on it.

So the list of purchase is:

From IKEA:
+ 3 2×2 EXPEDIT modules
+ 2 75cmx150cm LINNMON table tops

From a local DIY store:
+ 2 3cm x 3cm, 240cm long wood strip
+ 1 1cm x 3cm, 240cm long wood strip
+ 6 side casters (to be placed on top of the modules)
+ 6 small plastic caster (which will touch the sides of the top of the modules)
+ 12 medium rubber caster (under the modules, they’re a bit more expensive, but I do not want to leave marks on the wooden floor)

First I assembled the EXPEDIT modules, and placed them in place, and put the LINNMON table top above. As the wall behind my desk has a radiator, it restricts the length I have, so I had to cut the table top. Moreover, the corner is not 90 degrees, so I had to cut it accordingly. I used a circular saw for that purpose.

I also estimated the height I would need, and cut the other table top to use it as a side. Now LINNMON table tops have wood strips on four sides, but the middle is made of cardboard honeycomb, and I had to reinforce the side I had cut. For this purpose I had to reduce a strip of 3×3 to 3×2,8, and cast it inside the side. I then assembled the two table tops with three dowels.

Now to guide the modules smoothly, I used 3×3 wood strip, glued and screwed below the top, to which I screwed the small plastic custers, and on which roll the side custers. To place correctly the strips, I worked upside down. The spacing was like this:

+ Side table top
+ 1cm wide wood strip
+ 1cm empty space
+ EXPEDIT module
+ 1cm empty space
+ 3cm wide wood strip
+ 1cm empty space
+ EXPEDIT module
+ 1cm empty space
+ 3cm wide wood strip
+ 1cm empty space
+ EXPEDIT module
+ 1cm empty space
+ 3cm wide wood strip

I used bits of 1×3 wood strips to obtain the correct spacing. Making the guides themselves was a bit more complicated, as I had to use a router to make holes for the small plastic casters.

Finally to fix the table top to the wall, I used pieces of angle frames I had, screwing them to the wall and below the table top.

The corner before the hack

3 EXPEDIT 2×2, 2 LINNMON 150×75, 1 LINNMON 120×60 (for a future use)

The inside of the LINNMON is honeycomb

Adding and gluing a strip inside the LINNOM table top

Adjusting the hole in the table top

Thanks to the above the holes are well centered

The covering structure upside down

With the EXPEDIT module, upside down, to check the dimensions

Fixing the upper casters, with a 1cm spacing

Placing the guides, also with a 1cm spacing. Note the head of the guide, with the holes for the side casters

Gluing the guides

The upper structure is now fixed to the wall

Detail of the side casters: the white top caster, rolling on the guide, and a grey one in the hole of the guide, rolling on the EXPEDIT.