A password will be e-mailed to you.

Materials: KVARNA, two switches, double side sticking tape and some cable

Description: Make the stand from 50mm wide aluminum sheet. Drill a hole of 30mm diameter at the end and pass the bulb socket through it. You have to drill a small hole on the socket, just about 5mm above the stand and put the power cable in, then get another piece of cable and make the appropriate connections to connect the switch (that cable goes through the original cable hole in the socket).

2-728614

Apply two stripes of the sticking tape and you are done.

~ Plamen Todorov, Sofia, Bulgaria