Hackers Help linnmon-table7-550x309

Published on October 26th, 2016 | by Geffmon

3

Hackers Help: Higher Linnmon Table hack suggestions





Linnmon table hack

I recently picked up two Linnmon tops from my local IKEA store, and I am planning to mimic the build that is pictured above with only two tops instead of three. When I got home I realized that the legs were very short for someone of my stature and I have been brainstorming ways to possibly extend the length of the legs. I have considered ideas such as 3d printing but haven’t gotten any further than that. What does the intelligence of IKEA hackers have to suggest?

Friheten sleeper sofa pillow backs
LACK Monitor Stand on Rails (with USB hub)


The Author

3 Responses to Hackers Help: Higher Linnmon Table hack suggestions

  1. Theo says:

    If you don’t mind legs that are slightly smaller at the bottom, you could look into IKEA’s adjustable legs; OLOV (60-90cm) and GERTON (67-107cm).

  2. Cindy says:

    I’m an amateur potter and have seen systems that raise the height of a pottery wheel using PVC pipe. Som systems have holes drilled through the pipes to allow the height to be adjusted. The pipe would need to accommodate the circumstance of the table legs…

  3. Nikki says:

    If you look under the table in the picture, you can see where they’ve built up the height of the table with possible 2x4s. Depending on how much higher you need it, that would be the way to go.

Leave a Reply

Your email address will not be published. Required fields are marked *

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <strike> <strong>

Back to Top ↑