Pax

Published on June 1st, 2013 | by IH guest

0

Pax Built-in for sloping ceiling





Materials: PAX closet BIRKELAND doors FINTORP handle

Description: First I have measured the space between the closet and the ceiling this was about 20 cm. I have used 2 rows of aerated concrete blocks of 10 cm direct on the floor to raise the closet 10 cm.

After placing the blocks I had to cut all sides of the closet because at 160 cm (170cm from the floor) the roof slope began. Don’t forget to cut the right side, I messed up one panel :( . I have added some wood laths on the walls to mount the covering.

After this I have mounted a wooden lath over the closet to give it more strength and to mount the ceiling covering. After all closets were placed and connected to each other and to the wall I have screwed 12 mm carton board to finish. After grounding I have used a self adhesive MDF finishing profile to make a nice connection to the walls and ceiling. I have used Acrylic kit to finish it up and used white paint.

~ Bram van Tienhoven, NL Hendrik Ido Ambacht

Map It Out Desk
Bye Bye Lack Shelf: Alternative cat stairs


The Author

I am Jules' little helper on IKEAHackers. Helping to upload posts, moderate comments, do minor tweaks here and there.

Leave a Reply

Your email address will not be published. Required fields are marked *

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <strike> <strong>

Back to Top ↑