Pax

Published on June 1st, 2013 | by IH guest

0

Pax Built-in for sloping ceiling





Materials: PAX closet BIRKELAND doors FINTORP handle

Description: First I have measured the space between the closet and the ceiling this was about 20 cm. I have used 2 rows of aerated concrete blocks of 10 cm direct on the floor to raise the closet 10 cm.

After placing the blocks I had to cut all sides of the closet because at 160 cm (170cm from the floor) the roof slope began. Don’t forget to cut the right side, I messed up one panel :( . I have added some wood laths on the walls to mount the covering.

After this I have mounted a wooden lath over the closet to give it more strength and to mount the ceiling covering. After all closets were placed and connected to each other and to the wall I have screwed 12 mm carton board to finish. After grounding I have used a self adhesive MDF finishing profile to make a nice connection to the walls and ceiling. I have used Acrylic kit to finish it up and used white paint.

~ Bram van Tienhoven, NL Hendrik Ido Ambacht

Map It Out Desk
Bye Bye Lack Shelf: Alternative cat stairs
We will be moving. Don’t miss any hacks.
Be the first to know
IKEAhackers will be moving. Be the first to know of the new domain when it is ready. Enter your details and sign up now.


The Author

I am Jules' little helper on IKEAHackers. Helping to upload posts, moderate comments, do minor tweaks here and there.

Leave a Reply

Your email address will not be published. Required fields are marked *

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <strike> <strong>

Back to Top ↑