Type a keyword, eg. "PAX", "room divider" & find it
I'm not sure how you did it - do you have more info? I think it's nice and certainly priced right, but I have no indication of what you did to get there. Thanks!
@Anonymous above:As far as I can see the two "Valter's" are put next to each other and the pieces from the "Lycka" are the horisontal parts that mount them togetherVery sleek. Good job!
I dunno about this..... the way my laptop is made, those brackets to support the bottom of the laptop would cover the most important vent holes.
you could cut the bits from the lycka to adjust the width so it would block anything. kinda wondering how the lycka is attached to the ekby valter brakets. LH suggested glue, but I think something stronger is in order, no?
looks like lycka is discontinued? Anyone know of a usable alternative?
Don't know, but seems to me any pant hanger would work. They are available in stores like Target or Walmart. Good Luck!
I liked this hack so I went to IKEA today to purchase the necessary items. I ended up buying the larger 11" EKBY VALTER bracket in birch which works well with my 17" laptop. Since the LYCKA pants hanger is discontinued, I went with the BUMERANG pants hanger which matches the birch brackets perfectly. I used screws to attached the BUMERANG pieces to the brackets as pictured on the post. I decided to countersink the screws for the RULL knobs since I wanted the bottom surface to be flat. However in doing so the RULL knobs would not tighten completely. This was easily solved with the addition of a small washer between the knob and the bracket. It turned out very well and only took me about 20 minutes to complete.
I'm not really sure if you should consider this as cheap. My sister bought a laptop from austin.net.au and she saw cheaper accessories there.
Hi everyone, I made this laptop stand today with a slight variation. I also used two 11" EKBY VALTER brackets in birch. I bought the small blue LEGITIM chopping board, placed across the diagonal beams as a surface for the laptop to rest on. It was sturdy enough with just the chopping board attached to the brackets. I then used two of the wooden slats (piled on top of each other to make it 2x as thick) from the BUMERANG pants hanger to put a horizontal beam along the bottom on the slanted surface for the bottom of my laptop to rest against. This was better for me than putting two pegs on the bottom because I was able to raise my laptop (lenovo U410) up farther on the slope.One piece of advice is to use #4 or #6 type screws. I used #4 1" screws. First I tried using #10 1" screws but they were too thick and split the wood piece from the hanger.
Everyone is free to comment but IKEAHackers.net reserves the right to remove comments that do not contribute constructively to the discussion, contain profanity, personal attacks or seek to promote a personal or unrelated business. SPAM will be deleted. If you have a Blogger profile, you can click on the SUBSCRIBE BY EMAIL link that will show up below and receive all follow up comments on the hack via email.Don't have a Blogger profile? Create one for free here so you won't have to be be listed as "anonymous".